Characteristics of hydrocarbon open cleaning machine

（1）成本較低，投入較少的資金，即可實現清洗?？墒謩硬僮鳎逑催^程靈活快捷；

(1) Low cost and less investment can achieve cleaning. Can be manually operated, and the cleaning process is flexible and fast;

（2）需要保證一槽碳?xì)錆崈舳龋芪廴竞笮枰鼡Q，更換清洗液頻率相對高一些；

(2) It is necessary to ensure the cleanliness of the last tank's hydrocarbon, and if it is contaminated, it needs to be replaced. The frequency of replacing the cleaning solution is relatively high;

（3）針對一些有盲孔/疊層/通孔/夾縫的產品清洗效果較弱一些。

(3) The cleaning effect is weaker for some products with blind holes, laminations, through-holes, and gaps.

（4）安全風險相對高一些，碳?xì)淙軇┤菀讚]發損耗較大；

(4) The safety risk is relatively high, and hydrocarbon solvents are prone to volatilization and loss;

碳?xì)涑ㄩ_式普通超聲波/浸泡清洗工藝維護說明

Maintenance instructions for hydrocarbon open type ordinary ultrasonic/immersion cleaning process

（1）定期換液，每次換液建議更換一槽即可。通常槽碳?xì)鋱髲U或者做蒸餾再生處理，第二槽碳?xì)滢D(zhuǎn)移到槽，第三槽碳?xì)滢D(zhuǎn)移到第二槽，第四槽碳?xì)滢D(zhuǎn)移到第三槽，以此類推，槽加新液，保證一槽足夠干凈；

(1) Regularly change the liquid, and it is recommended to replace the last tank every time. Usually, the first tank of hydrocarbons is scrapped or subjected to distillation regeneration treatment, the second tank of hydrocarbons is transferred to the first tank, the third tank of hydrocarbons is transferred to the second tank, the fourth tank of hydrocarbons is transferred to the third tank, and so on. The last tank is filled with new liquid to ensure that the last tank is clean enough;

（2）每次換液倒槽時，要把槽底清潔干凈，如有過濾系統，需定期更換濾芯；

(2) Every time the liquid is changed and the tank is poured, the bottom of the tank should be cleaned thoroughly. If there is a filtration system, the filter element should be replaced regularly;

（3）如超聲波清洗無恒溫裝置，長期清洗溫度會上升，注意切勿讓溫度過高，否則安全隱患變大；

(3) If there is no constant temperature device for ultrasonic cleaning, the long-term cleaning temperature will rise. Be careful not to let the temperature be too high, otherwise the safety hazards will increase;

（4）秋冬季注意防靜電著火。

(4) Pay attention to preventing static electricity and fire in autumn and winter.

全封閉式清洗機特點

Features of fully enclosed cleaning machine

1、投入資金較大，一般都是自動化清洗操作，使用簡單方便；

1. The investment is relatively large, usually automated cleaning operations, which are simple and convenient to use;

2、安全風險相對較小，碳?xì)淙軇]發損耗較小；

2. The safety risk is relatively small, and the evaporation loss of hydrocarbon solvents is relatively small;

3、一般在設備可實現循環過濾及蒸餾再生，清洗品質更穩定，只需定期維護，不需頻繁換液；

3. Generally, the equipment can achieve cyclic filtration and distillation regeneration, resulting in more stable cleaning quality. It only requires regular maintenance and does not require frequent liquid changes;

4、對于有盲孔/疊層/通孔/夾縫的產品清洗效果相對較好。

4. The cleaning effect is relatively good for products with blind holes, laminations, through-holes, and gaps.

5、環保：臨0排放，可自然降解。

5. Environmental protection: Near zero discharge, naturally degradable.

真空清洗工藝維護

Vacuum cleaning process maintenance

1、定期更換濾芯，一般槽臟，更換濾芯頻率要比后槽的高，另外濾芯精度逐級提高；

1. Regularly replace the filter element. Generally, the first slot is the dirtiest, and the frequency of replacing the filter element is higher than that of the rear slot. In addition, the accuracy of the filter element is gradually improved;

2、建議3-5天更換一次濾芯，具體頻率視清洗產品品質而定；

2. It is recommended to replace the filter element every 3-5 days, and the specific frequency depends on the quality of the cleaning product;

3、建議每個月底清潔槽底一次；

3. It is recommended to clean the bottom of the tank at the end of each month;

4、建議每個季度整機換液清潔一次。

4. It is recommended to change the fluid and clean the entire machine once a quarter.